
Dual Band GSM900MHz / LTE 1800MHz Cell Phone Signal Boosters with Mini Design
Model. GW-17GD-VB
Cell Phone Signal Booster Description:
Dome Antennas are more popular because they project signal in all directions. Therefore, they are good for mounting on ceilings in central locations to project reception in 360 degrees fashion covering large square spaces.
Panel Antennas project signal in single direction. Therefore, they are good for installing on walls to cover rectangular areas like long corridors. They can be installed on ceilings to boost reception over multiple floors as they project reception downwards across multiple floors.
How does a signal booster work ?
Firstly, the cell phone reception is captured by the outside antenna. It is then amplified by the cellular repeater and rebroadcasted across the building or car through the inside antenna. The result is a boosted cell phone reception that culminates in more bars in your phone even in the remotest of places. You can then enjoy clearer calls (you won’t drop calls again) and faster internet browsing and rapid data downloads and uploads. This is how the cellphone signal booster works in your car or house. This is how all signal boosters work on all technology platform networks.
Cell Phone Signal Booster Introduction:
Signal Booster GW-17GD-VB is designed to enhance and improve the quality of mobile 2G GSM900&1800MHz connection. There’re black and white colors for options. The Led Indicator will show the current level of the input signal, which simplifies the installation of the external antenna. High quality aluminum shell provides an optimal cooling. This model, as simple in connection, installation and configuration, does not require special skills.
Cell Phone Signal Booster Specification:
Frequency Range | Uplink | Downlink | |||
GSM 900MHz | 890 - 915MHz | 935 - 960MHz | |||
DCS 1800MHz | 1710 - 1785MHz | 1805 - 1880MHz | |||
Max. Gain | 65dB | 70dB | |||
Max. Output Power | 15dBm | 17dBm | |||
Band width | Wide Band | ||||
Automatic Gain Control | >31dB | ||||
Ripple in Band | 8dB; | ||||
Noise Figure | ≤ 6dB | ||||
VSWR | ≤ 2.0 | ||||
Intermodulation Products | 9KHz~1GHz | ≤ -36dBm | |||
1~12.75GHz | ≤ -30dBm | ||||
Spurious Emission | 9KHz~1GHz | ≤ -36dBm | |||
1~12.75GHz | ≤ -30dBm | ||||
Time Delay | ≤ 1.5 μs | ||||
Frequency stability | ≤ 0.01ppm | ||||
MTBF | > 50000 hours | ||||
Impedance | 50 ohm | ||||
Power Supply | AC 90-264V,DC 6V/3A | ||||
Power LED | Power indicator | ||||
ISO(Alarm LED) | Red | Self oscillation or Strong input signal | |||
Green | Normal | ||||
Mechanical Specification | |||||
RF Connector | N-Female | ||||
Switch | Power Switch | ||||
Cooling | Heatsink Convection cooling | ||||
Humidity | < 90% | ||||
Operating Temperature | -20°C ~ +55°C | ||||
Environment Conditions | IP40 | ||||
Installation Type | Wall Installation | ||||
Size | 182mm×118mm×18mm | ||||
Weight | < 1.2Kg |
Other Frequencies for options:
Frequency Range | Uplink | Downlink |
EGSM900+DCS1800 | 880 - 915/1710 - 1785MHz | 925 - 960/1805-1880MHz |
GSM900+PCS1900 | 890 - 915/1850 - 1910MHz | 935 - 960/1930-1990MHz |
GSM900+ LTE2600 | 890 - 915/2500 - 2570MHz | 935 - 960/2620 - 2690MHz |
EGSM900+ LTE2600 | 880 - 915/2500 - 2570MHz | 925 - 960/2620 - 2690MHz |
GSM900+WCDMA | 890 - 915/1920 - 1980MHz | 935 - 960/2110 - 2170MHz |
EGSM900+WCDMA | 880 - 915/1920 - 1980MHz | 925 - 960/2110 - 2170MHz |
GSM850+PCS1900 | 824 - 849/1850 - 1910MHz | 869 - 894/1930 - 1990MHz |
GSM850+ AWS1700 | 824 - 849/1710 - 1755MHz | 869 - 894/2110 - 2155MHz |
CDMA800+WCDMA | 824 - 849/1920 - 1980MHz | 869 - 894/2110 - 2170MHz |
CDMA800+ DCS1800 | 824 - 849/1710 - 1785MHz | 869 - 894/1805 - 1880MHz |
DCS1800+WCDMA | 1710 - 1785/1920-1980MHz | 1805-1880/2110-2170MHz |
DCS1800+ LTE2600 | 1710 - 1785/2500-2570MHz | 1805-1880/2620-2690MHz |
WCDMA+ LTE2600 | 1920-1980/2500-2570MHz | 2110-2170/2620-2690MHz |
Cell Phone Signal Booster Features:
1. Coverage up to 500 m²
2. ALC Function
3. Simple in connection and installation
4. An optimal cooling with aluminum shell
5. Led indicators show working status and ISO alarm.
Support any cellular devices (voice & data & video)
FAQ:
1. After installing booster signal not be very good, indoor signal
coverage very small ?
> Adjust outdoor antenna's location and direction
> Change another high gain outdoor antenna
> Check whether cables are connected well
> Change more powerful repeater
2. Cell phone signal full bar, but communication quality bad ?
> Much closer distance between indoor and outdoor antenna,
separate them with a longer distance.
3. After installing booster not only signal be good, but also more
bad ?
> Much closer distance between indoor and outdoor antenna,
separate them with a longer distance.
4. Working good for long time, suddenly signal bad ?
> Check whether outdoor cable connectors are flooded
> Check whether power light is working normally
> If cables are not flooded and power light is working normally,
the booster should has problems and need to be sent back to factory
for repair.
Cell Phone Signal Booster Application:
Cell Phone Signal Booster Installation:
The booster is fixed onto the wall through expansion bolts.
A. Drill holes on the targeted place and install expansion bolts.
B. Align the holes with the expansion bolts, place flat washers,
spring washers, and nuts in turn, and tighten the nuts to fasten
the installing support.
C. Place the booster on and fasten it.
D. Connect cables and power cables to the booster respectively.
E. After installing the booster as described above, power on the
booster to check the operation status.
Connection:
A. BTS Port: donor antenna cable is connected with Outdoor Port;
B. MS Port: service whip antenna is connected with Indoor Port;
C. DC IN: connected with Power adaptor.
Our Workshop:
Our Company:
Greetwin Tech is a strong and reliable factory, focusing on the R&D and Manufacturing of Digital ICS Repeater, RF Repeater, Indoor Signal Distribution System, Trunk Amplifier, Band Selective Repeater for more than 10 years.
Shenzhen Greetwin Technology Co.,Limited
Shenzhen Greetwin Technology Co., Limited is one of the leading suppliers which specializes in designing and
manufacturing RF Jamming Equipment and Wireless Coverage Products.
Wireless Coverage Products include 2G 3G 4G LTE 5G RF
Repeater.
The RF Repeater solutions will bring smooth and clear
calls, support all bandwidths and mobile standards including TETRA,
iDEN, LTE700, GSM850, EGSM, GSM900, DCS1800, PCS1900, CDMA800,
CDMA450, LTE 4G, CDMA2000, 3G(WCDMA), LTE2600 and TDD-LTE series.
Such as, Wide band Repeater, Band selective Repeater, Digital Repeater, High Power Outdoor Repeater, Fiber Optic Repeater, ICS Repeater, Consumer Signal Booster, Power Amplifier.
We are committed to providing the best solutions for mobile operators, offering OEM and ODM service. Products can be customized according to different operators in the world and the output power are available from 0.01W to 20W.
RF Jamming Equipment include Cell Phone Signal Jammer,
RF Communication Jammer(20-6000MHz) and 20-200W Power amplifier.
GREETWIN is the foremost innovator in the field of RF
jamming, offering a comprehensive range of jamming equipment and
systems which have a proven record of reliability and performance
in all types of applications and environmental conditions.
In countering the ever-growing threat of remotely
controlled improvised explosive devices (RCIEDs), we has invested
heavily in the development of a range of multi-band,
very-high-power jamming systems for the protection of troop
transportation, military and police checkpoints, large governmental
establishments, bomb disposal squads and VIP convoys.
Such as, 5KM Drone jammer, UAV jammer, High power bomb
jamming devices, Military IED jammers, Digital programable jammer,
VIP Convoy Bomb Jammers (RCIED Jammers), Mobile Phone Signal
Jammers, Prison Jammers, Portable Jammers, Handheld Jammers, to
suit all types counter terrorism activities.
Our clients are government agencies, military, SWAT
team, prison, school, bank, law enforcement and VVIPs. We also
serve corporations and private individuals who must take
responsibility for protecting assets, proprietary information,
executives and family members.
GREETWIN products have been exported to more than 60
countries and regions around the world. Such as Southeast Asia,
Africa, Europe, South America and the Middle East.
Let us hand in hand and create a glorious cause!