
PreAmplifier Cell Phone Range Extender Improve Uplink Power 20dBm
The GREETWIN cell phone booster has been designed to prevent overloading or
interfering with existing networks. Operators have approved the
device to access their networks. It is important to buy a signal
booster that does not interfere with other networks. If not
purchasing from us, please make sure that the signal booster you
are going to buy has been approved by your carrier and have been
proven not to cause network interference.
Pre-amplifier is utilized when the input power of the repeater is
weaker than the suitable power level, pre-amplifier will boost the
input signals to a certain reasonable level, so that the repeater
can reach its full output power for a much larger coverage size.
Pre-amplifier has also been largely deployed to assist the Pico
repeater operation in rural areas. As it is known, the Pico
repeater only gets 5~15dBm output power in UL, so when the repeater
site is too far away from the BTS tower, the mobile phone signals
would not be strong enough to go back. Typical phenomena is that
people can see full bar signals on the mobile phone, but the phone
calls can't be initiated. So a pre-amplifier with 20dBm output
power in UL would increase the UL power level of the repeater so
that the signals can reach BTS tower.
pre-amplifiers are available in single, dual and triple mobile band
, i.e., not only we have pre-amplifier able to amplify one GSM900
band , but also a triple band one to support GSM900, DCS and WCDMA
at the same time.
It supports all current technologies of GSM850, GSM900, DCS, PCS;
CDMA450, CDMA800, CDMA1900, CDMA2000, WCDMA2100 and AWS.
Though it supports up to triple band , the pre-amplifiers are still
compact size, elegantly looking with low power consumption.
PreAmplifier Specification:
Frequency Range | Uplink | Downlink | |||
GSM1800 | 1710-1785MHz | 1805-1880MHz | |||
Max. Gain | 20dB | 20dB | |||
Max. Output Power | 20dBm | 0dBm | |||
Band width | Wide Band | ||||
Manual Gain Control | 31dB / 1dB Step | ||||
Automatic Gain Control | >30dB | ||||
Ripple in Band | CDMA,GSM≤6dB; DCS,PCS≤8dB; | ||||
Noise Figure | ≤ 6dB | ||||
VSWR | ≤ 2.0 | ||||
Intermodulation Products | 9KHz~1GHz | ≤ -36dBm | |||
1~12.75GHz | ≤ -30dBm | ||||
Spurious Emission | 9KHz~1GHz | ≤ -36dBm | |||
1~12.75GHz | ≤ -30dBm | ||||
Time Delay | ≤ 1.5 μs | ||||
Frequency stability | ≤ 0.01ppm | ||||
MTBF | > 50000 hours | ||||
Impedance | 50 ohm | ||||
Power Supply | AC 90-264V,DC 9V/3A | ||||
Power LED | Power indicator | ||||
ISO(Alarm LED) | Red | Self oscillation or Strong input signal | |||
Green | Normal | ||||
Mechanical Specification | |||||
RF Connector | N-Female | ||||
Switch | Power Switch | ||||
Cooling | Heatsink Convection cooling | ||||
Humidity | < 90% | ||||
Operating Temperature | -20°C ~ +55°C | ||||
Environment Conditions | IP40 | ||||
Installation Type | Wall Installation | ||||
Size | 204mm×128mm×27mm | ||||
Weight | < 1.5Kg |
PreAmplifier Features:
1. Wide band pre-amplifier to support all signals
2. ETSI & 3GPP 3GPP2 standards
3. Enough UPLINK power level of 20dBm to reach BTS
4. UL AGC 10dB range to ensure high linearity
5. UL IM3 meets with ETSI 3GPP 3GPP2 standards
6. Alarm LED's for error detection
7. Universal power range of 90V~265V
8. Elegant designlight weight low power consumption
PreAmplifier Support these systems:
Frequency Range | Uplink | Downlink |
CDMA 450 | 452.5 - 457.5MHz | 462.5 - 467.5MHz |
LTE700 A/B | 699- 716MHz | 729- 746MHz |
LTE700 C | 777- 787MHz | 746- 756MHz |
LTE700 D | 788- 798MHz | 758- 768MHz |
LTE 800 | 832- 862MHz | 791- 821MHz |
iDEN | 806- 824MHz | 851- 869MHz |
CDMA 800/GSM 850 | 824- 849MHz | 869- 894MHz |
GSM 900 | 890- 915MHz | 935- 960MHz |
EGSM | 880 - 915MHz | 925 - 960MHz |
AWS1700 | 1710- 1755MHz | 2110- 2155MHz |
DCS 1800 | 1710- 1785MHz | 1805- 1880MHz |
PCS 1900 | 1850- 1910MHz | 1930- 1990MHz |
WCDMA/3G 2100 | 1920- 1980MHz | 2110- 2170MHz |
LTE 2600 | 2500- 2570MHz | 2620- 2690MHz |
PreAmplifier Advantages:
1. can customize the Cover Image on the Cell Phone Signal Booster, design private styles
2. If there are strong input signal or severe self oscillation, ISO
LED is red.
3. If there are good input signal, AGC LED is green.
PreAmplifier Standard Package:
1) AC90-264V, DC9V/3A power supply adapter 1PCS
2) AC power cord (EU/US/UK/SA/China standard, etc) 1PCS
3) Installation kit 1PCS
4) User manual 1PCS
Application Diagram:
Shenzhen Greetwin Technology Co.,Limited
Shenzhen Greetwin Technology Co., Limited is one of the leading suppliers which specializes in designing and
manufacturing RF Jamming Equipment and Wireless Coverage Products.
Wireless Coverage Products include 2G 3G 4G LTE 5G RF
Repeater.
The RF Repeater solutions will bring smooth and clear
calls, support all bandwidths and mobile standards including TETRA,
iDEN, LTE700, GSM850, EGSM, GSM900, DCS1800, PCS1900, CDMA800,
CDMA450, LTE 4G, CDMA2000, 3G(WCDMA), LTE2600 and TDD-LTE series.
Such as, Wide band Repeater, Band selective Repeater, Digital Repeater, High Power Outdoor Repeater, Fiber Optic Repeater, ICS Repeater, Consumer Signal Booster, Power Amplifier.
We are committed to providing the best solutions for mobile operators, offering OEM and ODM service. Products can be customized according to different operators in the world and the output power are available from 0.01W to 20W.
RF Jamming Equipment include Cell Phone Signal Jammer,
RF Communication Jammer(20-6000MHz) and 20-200W Power amplifier.
GREETWIN is the foremost innovator in the field of RF
jamming, offering a comprehensive range of jamming equipment and
systems which have a proven record of reliability and performance
in all types of applications and environmental conditions.
In countering the ever-growing threat of remotely
controlled improvised explosive devices (RCIEDs), we has invested
heavily in the development of a range of multi-band,
very-high-power jamming systems for the protection of troop
transportation, military and police checkpoints, large governmental
establishments, bomb disposal squads and VIP convoys.
Such as, 5KM Drone jammer, UAV jammer, High power bomb
jamming devices, Military IED jammers, Digital programable jammer,
VIP Convoy Bomb Jammers (RCIED Jammers), Mobile Phone Signal
Jammers, Prison Jammers, Portable Jammers, Handheld Jammers, to
suit all types counter terrorism activities.
Our clients are government agencies, military, SWAT
team, prison, school, bank, law enforcement and VVIPs. We also
serve corporations and private individuals who must take
responsibility for protecting assets, proprietary information,
executives and family members.
GREETWIN products have been exported to more than 60
countries and regions around the world. Such as Southeast Asia,
Africa, Europe, South America and the Middle East.
Let us hand in hand and create a glorious cause!